Ignition Control Module

Ignition Control Module

Postby Red86GT » Sat Dec 29, 2012 8:27 pm

When your Fiero will crank but not turn over here is a possible reason.

There are many postings on the web about what can cause cranking but no turning over. I decided to go with what I felt was the most probably reason.

The ICM is easy to get to, remove and have tested at a local parts store. They are a reasonable price to replace. Mine tested bad. I replaced it and she fired right up.

So when problem solving the issue of cranking but not turning over make sure to check the ICM before going thru the many other more complicated possibilities.
Red86GT
 
Posts: 116
Joined: Tue Oct 02, 2012 6:27 pm
Location: High Point, NC

Re: Ignition Control Module

Postby Trinten » Sun Dec 30, 2012 12:19 am

Great tip! This is just the kind of stuff I'd love to see the board fill up with. Relevant topic-subjects, and accurate info! Thanks!
1986 Pontiac Fiero GT, 355 cubic inch small block Chevy putting down 371 HP and 381 ft/lbs torque at the wheels, with more to come!
User avatar
Trinten
Site Admin
 
Posts: 512
Joined: Mon Jun 04, 2012 7:02 pm
Location: Charlotte, N.C.



Return to Electrical




Users browsing this forum: No registered users and 1 guest

cron