by dgsmooth » Tue Oct 08, 2013 10:07 pm
howdy all, awsome site/forum here. well i'm a new fiero owner, just picked up a 86 gt for next to nothing as it had a bad engine knock/tick, which turned out to be a rod bearing. interesting part is that as i tore this engine apart and started measuring things to order parts, i found out its not a 2.8, but a 3.4. had the red 'fiero' upper intake plunum and everything so i never even asked. anyways my question is when a 3.4 has been put in place of a 2.8, where does the 2.8 end and the 3.4 begin? i know every conversion can be done differently, but typically speaking, would the computer and harness be fom the 2.8 still? what would need to be changed to put a 3.4 in place of the 2.8....would the intake have to be changed (ths one had the red 2.8 upper part at least)... would injectors ahve been changed, or would the 2.8 ones work? the cam had 4 failed lobed and that metal debris got into all bearings. luckily crank and pistons still in good shape, so i'm putting in all new bearings, a hone with new rings, new cam and lifters. i've ordered all that based on 3.4 an by size so thats all fine, but what led me down this question is the oil pressure sensor was broken off, so that got me asking wether i'd order the stock 2.8 fiero oil pressure sensor or order one from a 3.4? (or they might be the same). my guess would be the block, crank, pistons and rods, and heads would all be 3.4, then intake and everything else 2.8....i'm a heavy duty mechanic by trade so automotive/gas type intake systems not really my field of expertise. anybody who's savy with that stuff or has done a 3.4 conversion, i'd really appreciate a little advice or whatver insight anybody could throw at me. thanks to all and cheers for now.